Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Texas City, TX
We’ve documented every job we’ve done since 2015, and these are the ones that show what actually changes when a garage door gets fixed right. Photos don’t lie about bent tracks, rusted cables, or a door that finally seals straight. Below you’ll find real Texas City projects with the problem, the fix, and what the homeowner walked away with.
Recent Transformations
Torsion Spring Failure on a 16-Foot Clopay in Bayou Vista
The homeowner heard a loud bang from the garage at 6:30 a.m. during a Gulf Coast humidity spike, then couldn’t lift the door manually. We found a single broken torsion spring on a 16-foot Clopay that had been carrying the load alone; the previous installer never paired it. We installed a matched spring set, set the winding bars to the correct initial tension, and balanced the door at 8-10 pounds of lift force. The photo record showed the clean break at the coil and the new springs side-by-side before we left.
Rusted Bottom Section and Rotting Weather Seal in La Marque Terrace
Salt air from Galveston Bay had eaten through the bottom section of a 12-year-old door in La Marque Terrace, and the weather seal had hardened to the point it was trapping water against the steel. We sourced a matching 21-gauge replacement section from the original manufacturer, swapped the failing seal for a bulb-type vinyl rated for coastal exposure, and re-tensioned the spring to account for the slight weight difference. The documented record included a close-up of the rust pitting and the new seal compression against the driveway.
Misaligned Track and Derailed Roller in Moses Lake
A teenager in Moses Lake backed into the garage door frame hard enough to bend the vertical track and pop the top roller from its bracket; the door was hanging crooked and wouldn’t close past knee height. We replaced the damaged vertical track section, realigned the horizontal track for proper headroom clearance, and inspected all ten rollers for flat spots. The photo record showed the bent track measured with a level and the final gap spacing at the header bracket.
Dead LiftMaster Logic Board and Failing Safety Sensors in Amburn
The opener in Amburn had been clicking without moving the trolley carriage for two weeks, then quit entirely; the safety sensors were also throwing mismatched indicator lights. We diagnosed a failed logic board on the LiftMaster 8365W and misaligned photo eyes that had been knocked by a trash bin. We installed the replacement board, reprogrammed the existing remotes and keypad, and set the photo eyes at the manufacturer-specified 6 inches from the floor with a steady light pattern. The customer received photos of the old board’s diagnostic LED pattern and the new alignment measurement.
Complete Door Replacement on a 1970s Block Home in Texas City Proper
This 1970s block home in Texas City proper still had its original uninsulated steel door, which meant summer garage temperatures over 110 degrees and a top panel bent from a ladder strike years ago. We measured the rough opening, ordered a 2-inch insulated replacement with a thermal break and composite overlay to match the home’s updated exterior, and installed new vinyl weather seal on all four sides. The written scope included the R-value, the wind-load rating for Texas City’s exposure, and the exact color match number before any work started.
Emergency Cable Unwind During Tropical Storm Nicholas Aftermath in Kohfeldt Park
Tropical Storm Nicholas dropped enough wind-driven rain in Kohfeldt Park that this homeowner’s garage filled with water to the threshold, and the pressure differential plus debris impact caused the right lift cable to jump its drum groove and unwind completely. The door was hanging at 45 degrees with a three-inch gap at the left jamb when we arrived at 9 p.m. on a Sunday. We secured the door with locking pliers, replaced both 1/8-inch galvanized cables as a matched set since the left showed fraying we documented, and wound the drums to the correct number of turns for the door height. The photo record included the frayed left cable close-up and the water line on the jamb trim.
Want Results Like These?
Every project above follows the same process you’ll get: a flat written price before work starts, a documented photo record when we leave, and the 365-Day Done Right Promise backing it all. Call (409) 797-6585 and a live person will answer, 24/7, including emergency calls. We’ll name a technician, send an on-the-way text, and show up with the parts and the pricing already clear. Free estimates, free second opinions on any competing written quote, and no surprises on the invoice.
Written by Marcus Deller, Owner at Servo Garage Doors Texas City, serving Texas City since 2015.